Naim cd3 service manual serial#
Naim cd3 service manual update#

Slide the top panel back into place and, gripping the player at the front and back to retain the chassis, top cover and CD drawer in place, turn it over.ДЎ1. Apply mild thumb pressure to push the PIC into the socket so that it is fully home. Place the replacement PIC squarely into the socket so that its вЂњlegsвЂќ line up with the individual sockets. Use the PIC extraction tool, gripping the ends of the PIC, to lift it from its socket. The replacement PIC must be inserted with the same orientation.ДЁ. There is a semicircular indent and a dot located at one end of the PIC. Use the diagram below to identify the PIC Socket and PIC. Attach the earth strap around your left wrist (if right handed) and connect its clip to any prominent internal unpainted metallic feature of the chassis.Д§. With the player on the work surface facing away from you slide the top cover towards you away from the chassis and lift it clear. Hold the player at the front and back to retain the chassis, top cover and CD drawer in place and turn it over.ДҐ. Place the screw and washer safely to one side.Д¤. 2 Pozi-Drive screwdriver remove the earth screw and serrated washer located between the left hand side top cover fixings. Place the screws and bushes safely to one side.ДЈ.

2 Pozi-Drive screwdriver to remove the four bushed self-tapping screws.

Put them safely to one side.ДЇor Type Two fixing use a No. The rivets must be reused so do not discard them. Carry out the same levering procedure to remove the female part of each rivet. To do this, insert a flat bladed screwdriver or sidecutters underneath the domed head of each rivet and lever upwards removing the pin. Type Two fixing is four self tapping screws with plastic bushes.ДЇor Type One fixing the male and female parts of each plastic rivet must be prised apart and removed from the cover. Type One fixing is four reusable plastic rivets. A diagram on the underside of the CD3.5 additionally illustrates one of two types of top cover to chassis fixing that may be present on your player. Identify the top cover fixings to be removed from the diagram below. Invert the player on a clean work surface covered with a protective material - a towel for exampleДў.

Naim cd3 service manual update#

Ensure that the transit screws are fitted throughout the update procedure. Regardless of the selected display mode (track, time or off) the display will default to time when fast forward or fast reverse are operated or total programmed or disc time when stopped.ДЎ. Deselection of static pause works in the normal way. The player can be left in static pause indefinitely. If a player is paused for more than 10 minutes it will enter вЂњstatic pauseвЂќ mode in which the transport laser deactivates and the disc stops spinning. To select the standard control mode press and hold previous while the player is switched on. To select multi function mode press and hold next while the player is switched on.

This multi-function mode provides an alternative front panel interface in which fast forward, fast reverse and pause are selected by pressing and holding next, previous and play respectively.

Naim cd3 service manual serial#

The PIC update brings each player up to the user interface and play order programming feature set of CD players manufactured after February 2003 (contact the Naim Service Department for exact serial numbers).